High Powered Optics
homeshopspecialstech Stuffservicesabout uscontact us
 Home > Shop > Rifle Scope Installation > Tools > RTTAPE
Manufacturers
Information
About Us
Consulting
Contract R&D
Research Facilities
System Engineering
Shipping & Returns
Product FAQs
Contact Us
Shopping Cart
0 items
Product Description

RingTrue™ Tape - for Three Scopes

Tired of rings leaving scratches and gouges in your scope tube? Having problems with scope tubes slipping in the rings? Do your scope tubes have dents from over-tightening the rings to prevent slipping?  

Due to the matte surface on most rifle scopes, the surface contact between the scope tube and the rings is actually less than 50%. The hard anodize coating on many rings and scopes has a low coefficient of friction, enabling the scope to slip even when the proper torque is applied to the ring screws. Add to that a small misalignment between the rings, and the scope tube can slip under recoil causing scratches and gouges in the scope finish. Just the process of aligning the scope in the rings can leave marks on the scope tube.

RingTrue™ tape is made from an incredibly thin and strong polymer film that was developed for NASA. It has a weatherproof adhesive on one side and a glossy finish on the other side. The adhesive side is applied to the ring surface. After the scope is installed, the glossy side embosses onto the scope tube surface, creating a 100% surface contact between the scope tube and the tape. It is applied to the rings after lapping and 

  • Prevents the scope from slipping, especially on magnum rifles,
  • Protects the scope tube from being scratched by the rings,
  • Protects the rings from corrosion after lapping. 

We developed this tape to keep scopes from slipping on heavy recoil 50BMG rifles. It worked so well, we started selling it on our website and it has been our most popular item! 

What's included:

  • 12 pieces of RingTrue™ tape (enough for three scopes). Each piece is 1.0" wide by 3" long. 
  • 3 single edge razor blades. These premium razor blades hold their edge when trimming tape against the edge of the ring.
  • Instructions.

In most cases, we recommend lapping rings before installing the scope. Most rings that cost less than $100/pair have either extruded ring surfaces, or very rough ring surfaces due to a quick machining process. Lapping removes any small misalignment between the front and rear rings, which prevents stress, deformation or damage to the scope tube. Lapping enables less expensive rings to perform just like more expensive, fully machined tactical rings.

RingTrue™ Tape works best when used after lapping. Detailed instructions on lapping and taping rings are provided.

In some cases, RingTrue™ Tape may still be used without lapping the rings. For 34-35 mm scope tubes, for example, lapping bars in these sizes are not readily available. Fully machined tactical rings are typically used in these cases. When these rings are used on properly installed Picatinny rails, lapping usually is not needed because the rings are already properly aligned. In these cases, applying RingTrue™ Tape to the unlapped rings prevents the scope from being scratched, and increases contact area to prevent the scope from slipping. However, some heavy profile, rigid tactical rings fit so tightly that there is no room for RingTrue™ Tape and use of the tape is simply not possible.

RingTrue™ Tape for Three Scopes
Manufacturer: High Power Optics
Item#: RTTAPE
Out of Stock
$10.95
Quantity
Prices for internet orders only.
Not all products available in store.
Overall Customer Rating:
 5.0 out of 5
  |  Write a Review
Related Items
Wheeler Ring Alignment/Lapping Kit, 1"
Wheeler Ring Alignment/Lapping Kit, 1"
$47.99
HPO/Wheeler Professional Gunsmith 72 Piece Screwdriver Set 776737 w/ 3mm bit
HPO/Wheeler Professional Gunsmith 72 Piece Screwdriver Set 776737 w/ 3mm bit
$63.99
Boresight Collimator Calibration
Boresight Collimator Calibration
$30.00
RingTrue™ Reticle Alignment Tool II
RingTrue™ Reticle Alignment Tool II
$39.95
HPO/Wheeler Professional Gunsmith 89 Piece Screwdriver Set 562194 w/ 3mm bit
HPO/Wheeler Professional Gunsmith 89 Piece Screwdriver Set 562194 w/ 3mm bit
$74.99
Bushnell Professional Boresighter 74-3333
Bushnell Professional Boresighter 74-3333
$99.99
 
Payment Options

  
Security Assurance

NOTE: Prices, specifications and availability are subject to change without notice. We reserve the right to correct typographic, photographic and/or descriptive errors.
Copyright 2012 Outdoor Business Network | Powered by OBN | Privacy